Work with accessories allows to minimize designer work to two steps:
- accessories type selection;
- mounting parameters setup.
Other operations e.g. arrangement check-up, are executed automatically thus eliminating all possible errors. If necessary it is possible to replace one accessory type by another with automatic model rebuilding. It allows to vary product cost and create a wide range of furniture models adapted to any kind of furniture production and technology peculiarities.
Legs are fastened to product bottom along its front and back edges. If there are two pairs of legs of the cabinet they will be placed at set distance from bottom edges. If there are more legs, arrangement algorithm will consider vertical dividers. In first case the legs are placed regularly, in second case – at set distance in most wide sections. If necessary the legs can be supplied with clips for detachable kickboard mounting.
The tubes of two types can be mounted into cabinet:
- slide tubes with fastening to horizontal panels (telescopic lifts);
- common tubes that are fixed between vertical dividers via tube holders.
- inside the cabinet under the top with fastening to the sidewalls;
- behind the cabinet back wall if it is mounted into the groove;
- «cup» on cabinet back wall if it is sufficiently thick;
- plate on back edge of side wall;
- L shaped bracket on the top;
- a joint that is fastened to side walls.
Slide tubes are mounted automatically in the middle of section. Round tubes can be mounted horizontally and vertically as a support panel. At the same time the program automatically checks coaxial tubes mounting: at one height and with the same indent from cabinet bound.
If there is cabinet top overhang, backlight lamps can be mounted. They can be regularly arranged or designer can specify mounting points. Arrangement lines reproduce cabinet front edge line. E.g. if the overhang is semicircular, lamps will be arranged along the arc.
Backlight lamps are usually used in overhang kitchen furniture elements. They are mounted in cabinet back section area. In spite of great number of overhang constructions, there are six main groups according to design and mounting mode:
Regardless of selected overhang type, the holes for its mounting will be «drilled» automatically and panels geometry will be changed if necessary. It allows to avoid any kind of mounting errors.
Glides are accessories that can be used as legs for furniture on floor installation. Thus they are placed on panel edges that touch the floor. They are vertical panels or kickboards. You need to set the distance from panel edge for automatic glides mounting.
